Dodge 2005 PL Neon SRT4 Uživatelský manuál stáhnout pdf

January 2005

Distributor/Dealer Service Instructions for:

Emissions Recall D46

Reprogram PCM - OBD Fuel System Monitor

Models

2005 (DR) Dodge Ram Pick Up Truck

(KJ) Jeept Liberty

(ND) Dodge Dakota

NOTE: This recall applies only to the above vehicles equipped with a 3.7L engine and

built through September 24, 2004 (MDH 092421).

2005 (PT) PT Cruiser

NOTE: This recall applies only to the above vehicles equipped with a 2.4L engine and

built through September 22, 2004 (MDH 092216).

2005 (WK) Jeep Grand Cherokee

NOTE: This recall applies only to the above vehicles equipped with a 3.7L engine and

built through September 22, 2004 (MDH 092206).

2005 (TJ) Jeep Wrangler

NOTE: This recall applies only to the above vehicles equipped with a 4.0L engine, manual

transmission and built through September 24, 2004 (MDH 092406).

2005 (PL) Neon SRT4

NOTE: This recall applies only to the above vehicles built through September 23, 2004

(MDH 092306).

IMPORTANT: Many of the vehicles within the above build periods have already

been inspected or repaired and, therefore, have been excluded from this recall.

IMPORTANT: Some of the involved vehicles may be in distributor/dealer new

vehicle inventory. Distributors/Dealers should complete this recall service on these

vehicles before retail delivery. Distributors/Dealers should also perform this recall

on vehicles in for service. Involved vehicles can be determined by using the VIP

inquiry process.

1 2 3 4 5 6 ... 13 14

Shrnutí obsahu

Strany 1 - Emissions Recall D46

January 2005Distributor/Dealer Service Instructions for:Emissions Recall D46Reprogram PCM - OBD Fuel System MonitorModels2005 (DR) Dodge Ram Pick Up T

Strany 2 - Special Tools

14. Download the file from the USB key to the StarSCAN. Starting at theStarSCAN “Home” screen:a. Select “Flash Download”.b. Select “Use USB Device”.c.

Strany 3 - Service Procedure

19. Check all modules for Diagnostic Trouble Codes (DTC’s).NOTE: Due to the PCM programming procedure, a DTC may be set in othermodules (TCM, FCM, CCN

Strany 4

Completion Reporting and ReimbursementClaims for vehicles that have been serviced must be submitted on theDealerCONNECT Claim Entry Screen located on

Strany 5

Vehicle Lists, Global Recall System, VIP and Distributor/Dealer Follow upAll involved vehicles have been entered into the Global Recall System (GRS) a

Strany 6

EMISSIONS RECALL - REPROGRAM PCMDear: (Name)DaimlerChrysler has determined that your vehicle may be equipped with an improperlyfunctioning on-board em

Strany 7

SubjectThe Powertrain Control Module (PCM) on about 61,000 of the above vehicles(3,767 in International markets) was inadvertently programmed with inc

Strany 8 - WK Models):

Service ProcedureA. Reprogram the PCM (DR / KJ / PT / TJ / PL Models):The DealerCONNECT System, DRB IIIt (Diagnostic Readout Box scan tool),CH7000A fl

Strany 9 - FIGURE 2

10. Continue following the TechCONNECT on-screen instructions.11. Select the applicable update calibration.12. Select the “DRBIII” button located at t

Strany 10

18. Due to the PCM flash procedure, Diagnostic Trouble Codes (DTC’s) may beset in other modules (ETAX, BCM, MIC, SKIM, ABS, ORC) within thevehicle (if

Strany 11 - FIGURE 3

B. Reprogram the PCM (ND and WK Models)There are two methods which can be used to retrieve the flash file required toreprogram the PCM. The flash file

Strany 12

2. Connect the CH9410 StarSCAN ethernet cable to the StarSCAN and thedealer’s network drop.3. Download the flash file from the internet to the StarSCA

Strany 13 - Additional Information

7. Check all modules for Diagnostic Trouble Codes (DTC’s).NOTE: Due to the PCM programming procedure, a DTC may be set in othermodules (TCM, FCM, CCN,

Strany 14 - Buckle up

3. Press the button located below theCD/DVD ROM drive to open thedrive. Insert the StarSCANSoftware Update CD into theTechCONNECT PC and press thebutt